The triple buffer option will allow the CPU more time to process the audio signals but will result in latency. That will allow some audio devices to reach lower latencies and reduce audio underruns, that is, audible clicks and pops when the CPU load climbs too high. Under the audio settings, turn on ‘Mix in buffer switch’ and ‘Triple buffer’, below Sample Rate settings. You could change your sample rate by going to Audio Settings and selecting the sample rate from the Sample Rate dropdown menu in the right upper corner of the Audio Settings window.
That will also give you all the capabilities you need for good processing and optimizing your session. So you can bring your session’s sample rate down to 44.1 or 48 kHz.
It may give you some processing capabilities for specific plug-ins, but nothing more. Hence, if you’re operating at a higher sample rate, it will not result in any audible differences. However, higher sample rates consume more CPU power. Change the Sample Rate of your sessionĪny sample rate including and beyond 44.1 kHz will result in good quality audio.
To change the buffer rate, go to Options > Audio Settings > Buffer length and select the required buffer length. That is because a higher buffer length will result in lags and delays when you’re trying to do real-time monitoring of what you’re recording. Hence, a buffer length of 128 or 256 samples will be more optimal for recording purposes. However, this buffer length is only recommended when mixing-mastering a song.īuffer length or buffer size is the number of samples it takes for your computer to process any incoming audio signal. For example, a buffer length of 1024 or 2048 samples will optimize your system for higher performance. Increasing buffer length can substantially increase the performance of your CPU. DirectSound has a lot of unnecessary layers of processing which could be bypassed by selecting an ASIO driver. Under devices, you can select the ASIO device of your Audio Interface or FL Studio ASIO. The drop-down menu under Device will give you options for DirectSound and ASIO devices. You can select an ASIO driver by going to Options > Audio Settings > Input/ output and selecting any ASIO driver as an input/output device. Select an ‘ASIO’ Input/Output DeviceĪSIO drivers in almost every soundcard give you high-fidelity audio with low latency, hence decreasing CPU load.
4 Readings that you may like: How To Improve Your CPU Performance In FL Studio 1.
0 kommentar(er)
